Comments

Document Feedback - Review and Comment

Step 1 of 4: Comment on Document

How to make a comment?

1. Use this Protected Document to open a comment box for your chosen Section, Part, Heading or clause.

2. Type your feedback into the comments box and then click "save comment" button located in the lower-right of the comment box.

3. Do not open more than one comment box at the same time.

4. When you have finished making comments proceed to the next stage by clicking on the "Continue to Step 2" button at the very bottom of this page.

 

Important Information

During the comment process you are connected to a database. Like internet banking, the session that connects you to the database may time-out due to inactivity. If you do not have JavaScript running you will recieve a message to advise you of the length of time before the time-out. If you have JavaScript enabled, the time-out is lengthy and should not cause difficulty, however you should note the following tips to avoid losing your comments or corrupting your entries:

  1. DO NOT jump between web pages/applications while logging comments.

  2. DO NOT log comments for more than one document at a time. Complete and submit all comments for one document before commenting on another.

  3. DO NOT leave your submission half way through. If you need to take a break, submit your current set of comments. The system will email you a copy of your comments so you can identify where you were up to and add to them later.

  4. DO NOT exit from the interface until you have completed all three stages of the submission process.

 

'Academic Quality and Standards Committee Standing Committee' - Membership and Terms of Reference

Section 1 - Establishment

Background

(1) The Academic Quality and Standards Committee Standing Committee was established by Academic Senate in its current version on 17 April 2024 (AS191/9).

Purpose

(2) The purpose of the Academic Quality and Standards Committee Standing Committee (standing committee) is to make decisions on urgent matters between meetings of the full Academic Quality and Standards Committee (AQSC), and to perform other functions as detailed in Section 3 below.

Top of Page

Section 2 - Membership

(3) The members of the standing committee shall be:

  1. Chair, AQSC (chair)
  2. Director, Academic Quality and Standards
  3. three members of the AQSC nominated by the AQSC.
Top of Page

Section 3 - Functions and responsibilities

(4) The standing committee will:

  1. make decisions on routine matters, not requiring substantive discussion
  2. meet to decide urgent matters which arise between meetings of the AQSC and when it is not practical to convene a full meeting of the AQSC.
Top of Page

Section 4 - Meetings

Quorum

(5) A quorum shall be a majority; that is, half the entire membership plus one.

Meetings

(6) Meetings shall be scheduled as required and normally held via flying minute.

Agendas and minutes

(7) Agendas and minutes shall be prepared by Governance Services, Office of Governance and Corporate Administration.

Conflicts of interest

(8) Where a member has an actual, potential or perceived conflict of interest, they must declare this to the chair and at the standing committee meeting before discussion of the item of business.

Variations

(9) Variations to the terms of reference and/or membership must be approved by the Academic Senate.

Top of Page

Section 5 - Glossary

(10) Nil.